Arbor gates – A simple arbor covered with vines roses or flowers is a lovely accent to the end of his front foot or in a garden bed. Creating your own is easier and less expensive than you think. Measure the width of the walk to determine if you need to buy a piece of 10 or 12 feet wooden 2 x 6 – when cut in half, the Board (which forms the decorative header) must be at least a foot and longer means that the road is wide so you can cut the plate at an angle and have an overhang on each side. For example, my walking is just over 4 feet wide, so I bought a piece of 12 feet.
Visit your local home improvement store and purchase of wood, covered with nails, gravel and concrete. Pressure treated wood is your best choice for this project outdoors arbor gates. Dig a hole about 8 inches in diameter and a little more than a foot deep on both sides of the walk. Make sure that align directly across from each other and are a uniform depth. Check the depth by placing the pole and mark the point that even with the top of the hole – and then move the post to another hole to check is the same.
Arbor gates, drill a hole starting at the upper end of each post and screw in its auctions if using. Grab a friend or relative to help place their messages (you can do it alone but someone else makes it much easier). Put the post in the center of the hole and pour 4-5 inches of gravel. Use a level to determine when the post is straight and have your assistant hold it in place.
12 Simple Arbor Gates Ideas Photos